| G1946-60035 |
Cbl HV |
10349.9 |
| G1946-60036 |
Desolvation Assy |
166378.8 |
| G1946-60046 |
D.G heater weldment |
7011.1 |
| G1946-60048 |
HED Control Cable |
1071.7 |
| G1946-60049 |
Control cable |
312.6 |
| G1946-60050 |
Cbl APCI Int HV |
10596.9 |
| G1946-60052 |
RF Detect cable |
289.4 |
| G1833-65545 |
REACTION CELL ASSY |
39964.3 |
| G1833-65546 |
BRACKET TURBO PUMPS |
294.4 |
| G1833-65547 |
OCTOPOLE HOLDER PLATE |
1386.2 |
| G1833-65548 |
EM GATE FOR 7500C |
766.2 |
| G1833-65549 |
EM GATE |
1153.5 |
| G1833-65550 |
INSULATOR FOR PLATE BIAS |
1951.3 |
| G1833-65551 |
EINZEL GUIDE FOR 7500 OME |
2440.1 |
| G1833-65552 |
CONNECTOR FOR PLASMA |
1321 |
| G1833-65553 |
HERMETIC SEAL ASSY |
5470.3 |
| G1833-65554 |
BRACKET OF THE HERMETIC |
588.5 |
| G1833-65555 |
LENS INLET BOARD |
2981.4 |
| G1833-65556 |
COVER OF LENS INLET BOARD |
292.6 |
| G1833-65557 |
BRACKET FOR REACTION GAS |
1091.6 |
| G1833-65558 |
BRACKET 1 FOR THE MASS |
1074.1 |
| G1833-65559 |
SMALL COVER 7500C |
12890.4 |
| G1833-65562 |
PLATE BIAS FOR 7500C |
3532.2 |
| G1833-65563 |
FAN ASSY |
4830 |
| G1833-65564 |
DUCT |
5227.2 |
| G1833-65565 |
FAN FOR TURBO PUMP |
4303.8 |
| G1833-65580 |
CONNECTOR |
9656.5 |
| G1833-65585 |
INSULATOR BUSH,plastic,insulate ion lens |
1000.5 |
| G1833-65586 |
GASKET FOR BASE ASSY between plate bias |
1217.6 |
| G1833-65587 |
Spacer kit for EM gate, plastic |
1951.3 |
| G1833-65588 |
Guide plate for cell focus lens F/ICP-MS |
1174.9 |
| G1833-65589 |
Guide plate for cell exit lens ICP-MS |
625.9 |
| G1833-66002 |
Cable for octopole driver |
2869.2 |
| G1833-66003 |
Bracket (Pre filter part, Slim Ring QP) |
981.6 |
| G1833-66004 |
Bracket (Pre filter part, Eagle QP) |
981.6 |
| G1833-66014 |
Support part phase assy,unmounted diode |
134.9 |
| G1833-66015 |
Fan assy for TMP axial fan |
5521.5 |
| G1833-66019 |
Interface Chamber ICP MS |
63693.4 |
| G1833-66021 |
Spring hose plastic w/o fit,reinforced |
574.6 |
| G1833-66023 |
Vacuum cntr, alum,unthread, vent turbo |
3637.7 |
| G1833-66025 |
Cable, sysI/O, insltd,less than 80V data |
774.2 |
| G1833-66027 |
Fan assy for intro bd axial fan |
3267 |
| G1833-66028 |
Vauum chamber, for agilent 7500 ICP-MS |
30271.5 |
| G1833-66029 |
Vent valve filter relief valve |
1661.1 |
| G1833-66030 |
Power Supply |
57067.8 |
| G1833-66032 |
SF Water Cooling Block,part of ICP-MS |
8848.8 |
| G1833-66039 |
EINZEL LENS GUIDE |
3809.7 |
| G1833-66040 |
Cell Ectrance Guide |
5339.7 |
| G1833-66043 |
INSULATOR PLATE,POM |
304.1 |
| G1833-66044 |
Gate for Slim Ring quad/Omega Lens |
766.2 |
| G1833-66045 |
Thumbscrew, M3x11mm. Qty.2 |
404.8 |
| G1833-66046 |
M3 x 8mm screw, Qty. 10 |
8190.1 |
| G1833-66047 |
EXIT GUIDE, PEEK |
3357.5 |
| G1833-66048 |
Plate, stainless steel |
949.9 |
| G1833-66049 |
INSULATOR PLATE, POM |
606.5 |
| G1833-66050 |
SHIELD BRACKET, stainless steel |
709.2 |
| G1833-66054 |
Plastic Pipe for Drain Vapor |
1571.7 |
| G1833-66055 |
Sealing tape of Top Cover (7500) |
5235.4 |
| G1833-66057 |
New-RF generator |
123762.6 |
| G1833-66059 |
TORCH BOX ASSY |
25421.2 |
| G1833-66060 |
QUAD PIN |
4412.3 |
| G1833-66062 |
Screw for QP Prefilter |
2439 |
| G1833-66063 |
Quadropole cleaning frame assembly |
11681.8 |
| G1833-66065 |
Water tub tube kit for ICPMS G31xxA |
5581.8 |
| G1833-66066 |
Shield Bar, CONTACT BAR W/ HOLDER |
9005.6 |
| G1833-80215 |
Analog output cable, EM to feedthrough |
788.2 |
| G1833-80242 |
Dust Cover Hinge (right) |
522.4 |
| G1833-80254 |
MASSFLOW CONTROLLER |
36359.7 |
| G1833-80268 |
Dust Cover Hinge (left) |
1494.6 |
| G1833-80325 |
Swing Clamp NW20/25 |
480.6 |
| G1833-80990 |
New-Varian Turbo pump controller |
78316.8 |
| G1833-81002 |
HVY-Dry Scroll PmpMSPB0396 |
139546.6 |
| G1833-81003 |
New-HVY-E2M18 Pump 208V w/Edwards45 |
78655.2 |
| G1833-81004 |
New-HVY-E2M18 Pump 230V w/Edwards45 |
70143.1 |
| G1833-81011 |
New-Turbo Pump Ext200/200H |
225198.7 |
| G1833-89012 |
EXCH-Edws SF Pump 7500c+cs |
153167.4 |
| G1833-89990 |
EXCH-Varian Turbo controller(SQ188) |
58156 |
| G1833-90003 |
OPERATORS MANUAL(E) |
2278.8 |
| G1833-90004 |
Mnl, Agilent 7500 ICP-MS hardware manual |
1826.9 |
| G1833-90005 |
Application Handbook (ENG) |
945.6 |
| G1833-90009 |
7500 INSTALLATION GUIDE |
538.6 |
| G1833-97005 |
Application Handbook (JPN) |
1176.7 |
| G1834-60273 |
ICP-MS ChemStation B.03.03 |
184 |
| G1834-60274 |
ICP-MS CHEMSTATION REV.B.03.04 |
289.5 |
| G1834-60275 |
ICP-MS ChemStation B.03.05 (repl. media) |
2772.9 |
| G1834-60276 |
ChemStation Release B.03.06 (Repl.Media) |
400.2 |
| G1888-80000 |
Headspace Optical Alignment Gage Set |
39134.1 |
| G1946-20030 |
Lens 2 |
632.9 |
| G1946-20034 |
Quad Support Ring |
848 |
| G1946-20043 |
Base Washer |
930.5 |
| G1946-20100 |
CONTACT RING |
2321.8 |
| G1946-20109 |
VCap spacer |
712.6 |
| G1946-20111 |
T nut |
1678.7 |
| G1946-20115 |
ALIGNMENT WASHER |
946.6 |
| G1946-20127 |
Capillary exit spacer |
1643.1 |
| G1946-20143 |
Lens spacer |
1643.1 |
| G1946-20148 |
Lens holder Moly Quad |
5407.2 |
| G1946-20149 |
Turbo Pump Heat Sink |
2138.3 |
| G1946-20150 |
Capillary Mount |
1546.9 |
| G1946-20151 |
Sleeve Capillary Mount |
629.6 |
